Searched for "40142000"
Full Flow. Pol X 1/4" Barb with 7/8" Hex Nut. MUST BE INSTALLED BY TRAINED PERSONNEL IN ACCORDANCE WITH NFPA 58 & 54 STATE AND LOCAL CODES
- Male POL x Hose Barb fitting
- Heavy duty brass construction
- Hard Nose POL
- Hose ID: 1/4"
Flexible thermoplastic UL and CGA approved hose. The MER613 Series hoses are rated up to 350 PSIG working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules.
- cULus listed for lengths up to 60 in.
- 3/8 in. female flare swivel connections
- 400,000 BTU capacity
- Flexible thermoplastic UL and CGA approved hose
Flexible thermoplastic UL and CGA approved hose. The MER613 Series hoses are rated up to 350 PSIG working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules.
- cULus listed for lengths up to 60 in.
- 3/8 in. female flare swivel connections
- 400,000 BTU capacity
- Flexible thermoplastic
- 12 ft. L
- 3/8 in. hose I.D.
3/8 in. Female Flare Swivel and 3/8 in. Female Flare Swivel connections. These hoses are rated up to 350 psig working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules.
- Hoses are great for RV LP gas applications
- 3/8 in. hose I.D.
- 12 in. L
- Flexible thermoplastic UL and CGA approved hose
This 24 in. hose connector is used to connect Regulators to BBQ Grills, Camp Stoves, Patio Heaters and Other Appliances using LPG. For Very High or Low pressure. Ready to Install.
- To connect regulators to BBQ grills, camp stoves, patio heaters and other low pressure appliances using LPG
- Thermoplastic hose 350 psi maximum working pressure
- 24 in. L x 3/8 in. MNPT x 3/8 in. swivel flare fittings
- UL listed
Flexible thermoplastic UL and CGA approved hose. The MER613 Series hoses are rated up to 350 PSIG working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules.
- cULus listed for lengths up to 60 in.
- 3/8 in. female flare swivel connections
- 400,000 BTU capacity
- Flexible thermoplastic UL and CGA approved hose
- 4 ft. L
Hose fittings connect, control, change the direction of, and terminate the flow in piping and hose systems. This adapter is for connecting a hose to a male threaded connection of a different diameter. Hose barb on one end and male NPT threads on the other. Brass for corrosion resistance, ductility at high temperatures, and low magnetic permeability.
- Barbed fitting for a tight seal on hoses and NPT threads for a tighter seal than straight threads
- Barb x 3/8 in. female flare swivel
- Contains lead
- For use with plastic or rubber hose
- Nut: 3/8 in. Female flare swivel
- Hose barb: 3/8 in.
Flexible thermoplastic UL and CGA approved hose. The MER613 Series hoses are rated up to 350 PSIG working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules.
- cULus listed for lengths up to 60 in.
- 3/8 in. female flare swivel connections
- 400,000 BTU capacity
- Flexible thermoplastic UL and CGA approved hose
Designed to provide convenient quick connect and disconnect for low pressure gas appliances with 100% positive gas shut off at female coupler end of the connection. Maximum operating pressure 1/2 psig. For indoor and outdoor applications.
- 1-piece coupler body
- Approved for all low-pressure gas applications
- Convenient wrench flats for securing connection points
- Durable all brass construction
Flexible thermoplastic UL and CGA approved hose. The MER613 Series hoses are rated up to 350 PSIG working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules.
- cULus listed for lengths up to 60 in.
- 3/8 in. female flare swivel connections
- 400,000 BTU capacity
- Flexible thermoplastic UL and CGA approved hose
- 3 ft. L
Flexible thermoplastic UL and CGA approved hose. These hoses are rated up to 350 PSIG working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules. WARNING: An excess ow valve will not activate if there is a break or leak downstream of the valve that does not equal or exceed the closing ow of the valve or if the excess ow valve installed exceeds the ow capacity of the system. See the Excess Flow Warning page (PG. 18) for more information regarding the use of excess ow devices.
- Hoses are suitable for high or low pressure applications
- 1/4 in. hose I.D.
- FF swivel x FF swivel
- Flexible thermoplastic UL and CGA approved hose
- 6 ft. hose length
This 30 in. hose connector is used to connect Regulators to BBQ Grills, Camp Stoves, Patio Heaters and Other Appliances using LPG. For High or Low pressure. Ready to Install.
- 1/4 in. I.D. hose
- Thermoplastic hose
- 30 in. L
- 350 psi maximum working pressure
- 3/8 in. MNPT x 3/8 in. swivel f flare fittings
- UL listed
The MER613 Series hoses are rated up to 350 PSIG working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules. WARNING: An excess ow valve will not activate if there is a break or leak downstream of the valve that does not equal or exceed the closing ow of the valve or if the excess ow valve installed exceeds the ow capacity of the system. See the Excess Flow Warning page (PG. 18) for more information regarding the use of excess ow devices.
- cULus listed for lengths up to 60 in.
- 3/8 in. female flare swivel connections
- 400,000 BTU capacity
- Flexible thermoplastic UL and CGA approved hose
3/8 in. Female Flare Swivel and 3/8 in. Female Flare Swivel connections. These hoses are rated up to 350 psig working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules.
- Hoses are great for RV LP gas applications
- 3/8 in. hose I.D.
- 96 in. L
- Flexible thermoplastic UL and CGA approved hose
This 60 in. hose connector is used to connect Regulators to BBQ Grills, Camp Stoves, Patio Heaters and Other Appliances using LPG. For High or Low pressure. Ready to Install.
- 1/4 in. I.D. hose
- Thermoplastic hose
- 60 in. L
- 350 psi maximum working pressure
- 3/8 in. MNPT x 3/8 in. swivel f flare fittings
- UL listed
The RV Thermo Pigtail (Type I ACME) provides a safe, user-friendly connection from your Marshall Excelsior MEGR-253/253H regulator to a standard LP gas cylinder without the use of a wrench. The easy to tighten nylon nut swivels on a connector fitting that is heat sensitive. Inside the brass nipple is a flow-limiting device designed to sense excess gas flow. If excessive gas flow is detected, the RV Thermo Pigtail will shut down the flow to a maximum of 10 SCFH (by-pass flow).
- Note: MEC Green type I nut for use on RV application only (200,000 BTU per hour)
- Between 240 degree F and 300 degree F the brass nipple displaces (approximately 1/4 in.) closing the cylinder valve module and stopping the flow of gas from the container
- Red female QCC, type I x 1/4 in. MNPT
- Flexible thermoplastic UL and CGA approved hose
- 15 in. hose length
These hoses are rated up to 350 psig working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules. Warning: An excess ow valve will not activate if there is a break or leak downstream of the valve that does not equal or exceed the closing ow of the valve or if the excess ow valve installed exceeds the ow capacity of the system. See the Excess Flow Warning page (PG. 18) for more information regarding the use of excess ow devices.
- 1/4 in. hose I.D.
- cULus listed for lengths up to 60 in.
- Tank connection: POL
- Flexible thermoplastic UL and CGA approved hose
These hoses are rated up to 350 psig working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules. Warning: An excess ow valve will not activate if there is a break or leak downstream of the valve that does not equal or exceed the closing ow of the valve or if the excess ow valve installed exceeds the ow capacity of the system. See the Excess Flow Warning page (PG. 18) for more information regarding the use of excess ow devices.
- Male hard nose POL (7/8 in. nut) x 1/4 in. male inverted flare
- 1/4 in. hose I.D.
- Tank connection: POL
- Flexible thermoplastic UL and CGA approved hose
The Type I (QCC) connectors (ME517, ME518 and ME519 Series) are designed with a built-in excess ow feature and a positive shutoff that will not allow gas to ow until the connector is fully engaged. In case of a fire the built-in thermal protection on the QCC connector melts allowing the nipple to disengage from the tank connection and stop the ow of propane. These QCC connectors also provide a positive back check seal at disconnect to eliminate the propane in the hose from being released into the atmosphere.
- Inlet: 1-5/16 in. female acme
- Flow capacity: 100 SCFH air/200,000 BTUH
- Thermal protection
- 1/4 in. hose barb
MEC # ME1656 is a refillable cylinder fitting. Soft Nose POL with 1/4 Barbed Hose Fitting. Brass with Plastic Hand wheel. No Excess Flow Valve.
- Plastic hand wheel fits over the hex fitting to enable hand tightening of the POL connection
- Inlet: POL with rubber seal O-ring
- Outlet: 1/4 in. barbed gas line fitting (fits 1/4 in. I.D. hose size)
- No excess flow valve item # ME1655 is available with 0.9 GPM excess flow valve
The RV Thermo Pigtail (Type I ACME) provides a safe, user-friendly connection from your Marshall Excelsior MEGR-253/253H regulator to a standard LP gas cylinder without the use of a wrench. The easy to tighten nylon nut swivels on a connector fitting that is heat sensitive. Inside the brass nipple is a flow-limiting device designed to sense excess gas flow. If excessive gas flow is detected, the RV Thermo Pigtail will shut down the flow to a maximum of 10 SCFH (by-pass flow).
- Note: MEC Green type I nut for use on RV application only (200,000 BTU per hour)
- Between 240 degree F and 300 degree F the brass nipple displaces (approximately 1/4 in.) closing the cylinder valve module and stopping the flow of gas from the container
- 20 in. L
- Flexible thermoplastic UL and CGA approved hose
These hoses are rated up to 350 psig working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules. Warning: An excess ow valve will not activate if there is a break or leak downstream of the valve that does not equal or exceed the closing ow of the valve or if the excess ow valve installed exceeds the ow capacity of the system. See the Excess Flow Warning page (PG. 18) for more information regarding the use of excess ow devices.
- cULus listed for lengths up to 60 in.
- 1/4 in. hose I.D.
- Use on 2 bottle systems with 2-stage automatic changeover regulators or regulators with T-checks
- Flexible thermoplastic UL and CGA approved hose
These hoses are rated up to 350 psig working pressure with a 400 lbs. pull test rating. Each hose comes with 2 ends and fully crimped brass ferrules. Warning: An excess ow valve will not activate if there is a break or leak downstream of the valve that does not equal or exceed the closing ow of the valve or if the excess ow valve installed exceeds the ow capacity of the system. See the Excess Flow Warning page (PG. 18) for more information regarding the use of excess ow devices.
- cULus listed for lengths up to 60 in.
- 1/4 in. hose I.D.
- Use on 2 bottle systems with 2-stage automatic changeover regulators or regulators with T-checks
- Flexible thermoplastic UL and CGA approved hose
Secure Seal Adapter. 1/4 in. QC x 1/4 in. SAE 90 degree. All brass adapter.
- Secure seal adapter
- 1/4 in. QC x 1/4 in. SAE 90 degree
- UL for R410A
- Solid brass